Hot Tub Instructions

Download the printable one-page PDF

Control panel diagram: JETS, AUX, LIGHT on the left; WARM, MODE, COOL on the right; temperature display in the center

The one rule

Use only WARM ▲ and COOL ▼ to set the temperature.

While the display is flashing, press nothing else. Wait for it to stop flashing and show the water temperature again. The only exception is switching modes (green box below).

Setting the water temperature WARM ▲ COOL ▼

1. Press an arrow onceThe display flashes and shows the current set temperature (not the water temperature).
2. Press again while flashingEach press of WARM raises the setting by 1°. Each press of COOL lowers it by 1°.
3. Stop pressingAfter 5 seconds the display goes solid and shows the actual water temperature again. Done.

Range 80°F to 104°F (maximum). Heating is slow, so set it early and keep the cover on while it warms up. The reading is only accurate after the pump has run a couple of minutes.

Not heating? Check the mode WARM ▲ or COOL ▼ then MODE

How to tell: in Standard mode the display shows only the temperature. If it alternates between the temperature and Ecn or SLP, the tub only heats during filter cycles and the water will stay cool.

  1. Press WARM or COOL once. The display starts flashing.
  2. While it is flashing, press MODE. The mode advances one step: Standard → Economy → Sleep → Standard.
  3. Repeat steps 1 and 2 until Std appears for a moment. The tub is now in Standard mode and will heat.

Jets JETS AUX

  • Press JETS once for LOW jets.
  • Press JETS twice for HIGH jets.
  • Press a third time to turn the jets off.
  • AUX runs the other jets: press once for on, again for off.

High and AUX shut off after 15 minutes. Low may run by itself now and then to heat the water. That is normal.

Lights LIGHT

  • Press LIGHT once to turn on the LED lights.
  • Press again to cycle through the color patterns.
  • Keep pressing until the lights turn off.

Lights shut off by themselves after 4 hours.

Please do not

  • Hold any button down. Short presses only, under 2 seconds. Holding a button can open settings menus.
  • Press MODE except as shown in the green box above.
  • Leave the cover off. Cover and latch the tub after every use.
  • Turn off the breaker or unplug the tub.
  • Bring glass into or near the tub.

Safety and display messages

  • Supervise children at all times. Limit soaks to 15 minutes at 104°F.
  • Pr on the display: the tub is restarting. Wait 5 minutes.
  • OH, OHS, HH, OHH: too hot. Do not enter. Remove the cover and let us know.
  • Ecn or SLP alternating with the temperature: the tub is not in Standard mode. See the green box above.

Questions or anything not working? Reach us through the Contact page.